Activeforever PresSsion Sequential Compression Device Multi 3 ( Manuel d'utilisateur télécharger pdf (Page 10)

PresSsion

Gradient Sequential - Multi 3 & Multi 6

OOPPEERRAATTIIOONN

1. Place the unit on a firm and level surface.

2. Plug the power cord (female end) into the power cord receptacle. This is

located on the left side of Multi 6, and on the front of the Multi 3.

3. Plug the other end of the power cord (male end) into a grounded, electrical

outlet.

NOTE: The pump operates best at room temperature. If the unit has been

stored below normal temperature, allow it to warm to room temperature for

proper operation.

4. Connect the air supply hose to the air supply connection. The connection is

located on the left side of the Multi 6, and on the front of the Multi 3.

5. When using only one garment, seal the upper row of holes (3 on the front of

the Multi 3, and 6 on the left side of the Multi 6) with the blanking plug

provided.

6. Connect the air supply hoses into the fittings on the garment.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Pas de commentaire

Activeforever PresSsion Sequential Compression Device Multi 3 ( Manuel d'utilisateur Page 10