Activeforever Snow Joe Ultra 13.5 Amp Electric Snow Thrower Manuel d'utilisateur

© 2011 by Snow Joe, LLCAll rights reserved. Original instructions.OPERATOR’S MANUALSAVE THESE INSTRUCTIONS1IMPORTANT!Safety InstructionsAll Operators

102. The chute deector on the top of the discharge chute controls the height of the snow stream. Loosen the knob to raise or lower the deector to t

112. Loosen the middle 2 sets of nuts and bolts to change the worn rubber plate, assemble and tighten it on reverse step (Fig. 23).3. Install the ne

12 Note: To replace the pulley, remove the outer nut, the left handed nut in the opposite direction (clockwise to loosen and counterclockwise to tigh

13NOTES

14A Two-Year Full Warranty for residential use in the United States and CanadaGeneral Conditions: Snow Joe, LLC warrants this product to the origina

23. Personal Safetya. Stay alert – Watch what you are doing and use common sense when operating the snow thrower. Do not use the machine when tired,

3TECHNICAL DATAVoltage rating 120 V, 60 HzPower 13.5ALight 12V 20W (Model SJ621 only)No-load speed 2450 min¯'Weight (SJ620) 31

Safety SymbolsThe following table describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machi

AssemblyGetting Started1. Remove the snow thrower and all other items from the box.2. Determine the left and right hand side of the snow thrower by

62. Lift the chute deector and lock securely onto the discharge chute (Fig. 6).3. Raise or lower the chute deector to the desired height of the sn

7OperationNote: Before using this machine, make sure that the power source you will use complies with the specications detailed in this manual. Befor

Powering On and Off1. To power on , rst press the Safety Switch Button found along side the switch housing (Fig. 15).2. While holding the Safety Sw

3. When moving the snow thrower, use the wheels on one side as the pivot point. Slightly tilt the snow thrower on this pivot point to move it forward